How To Find Stud In Ceiling Without Stud Finder
One side will usually be nailed to a stud.
How to find stud in ceiling without stud finder. Extend the tape out 16 inches. If you get a hollow sound then you need to extend your tape to 24 inches and knock again. Since the baseboard should be attached to the studs look to see if you can spot where it might have been nailed.
If the sound is not hollow then you have found your stud. You can use tape or even dental floss to drag a refrigerator magnet across the wall to find the stud. To find and mark the side edges of a stud start at your mark or best estimate of the stud location and drive a 1 1 2 or 2 inch finish nail through the drywall and into the stud.
This method may seem a bit unorthodox but it works. These holes dimples are generally filled with caulk and painted but you may be. Wait until the magnet sticks to the wall and then you have found your stud.
If you don t find signs of a stud 16 inches. Look for the same signs of a stud in that area or rap on the wall sharply with your knuckles and listen for a solid sound instead of a hollow sound. The stronger the magnet the better.
5 ways to find a stud without a stud finder 1. Measure from an outlet remove an outlet cover and inspect the outsides of the box. Mark the center of the stud.
Stop hammering once you feel the stud s resistance. Pull out the nail move it over 1 4 inch and hammer again. Slowly move the unit back and forth along the desired area until the unit beeps and displays a full bar to indicate the edge of a stud.