Installing Crown Moulding On Ceiling
Steps on how to install crown molding use a self locking c clamp to secure a short 1x4 to the saw table.
Installing crown moulding on ceiling. Plywood to fill the gap between the soffit and the ceiling creating a solid gluing and nailing surface for both the soffit and the fascia that comes later. Install strips of 3 4 in. Then glue and nail.
You can t do it like any other trim pieces because the molding sits at an angle between the wall and the ceiling image 1. Nail the first length of molding in place. This three piece crown molding technique simplifies installation and the results are spectacular.
Crown molding is usually nailed to the wall studs along the bottom edge and into the ceiling joists above a lot of stud finder work. What you need for crown molding installation. Sand and file any high spots to create a tight fit.
Cut the molding swivel the saw to a 45 degree angle to match the direction of the molding set the board against the saw at the mark and make the cut. Fasten the backer with pl glue and 2 1 2 in. Working either clockwise or counterclockwise affix each piece of molding.
Use finish nails to install the first length of molding. Nail the rest of the molding in place. Set the crown molding upside down against the saw fence and the 1x4 stop block.
100 grit sandpaper is. Cut the corners of the molding. Apply masking tape to walls.